Skip to content

Glue-bead thickness inspection after soldering

Inspect the thickness of protective glue beads applied after reflow soldering. Laser sensors inspect the glue-bead thickness at defined points.

Glue-bead thickness inspection after soldering

Inspect the thickness of protective glue beads applied after reflow soldering. Laser sensors inspect the glue-bead thickness at defined points.

Application challenge

Inspect the thickness of protective glue beads applied after reflow soldering.

Measurement method and system

Laser sensors inspect the glue-bead thickness at defined points.

System components named by the manufacturer

  • optoNCDT 1420

Manufacturer source

The problem

Inspect the thickness of protective glue beads applied after reflow soldering.

The method

Laser sensors inspect the glue-bead thickness at defined points.

Frequently asked questions

Answers to the most common questions about our products and services

Inspect the thickness of protective glue beads applied after reflow soldering.

Laser sensors inspect the glue-bead thickness at defined points.

Before configuring a system, define the measured quantities, operating ranges, tolerances and required measurement rate, along with environmental conditions, installation constraints and system interfaces.

Didn't find the answer you were looking for?

Talk to an expert

More information

Contact us

Tell us what you need to measure and an engineer will get back to you.

Send us a message

Email or phone — one of them is enough

Email or phone — one of them is enough

0 of 500 words

Open in Google Maps (opens in a new tab)